Anthem AVM 20 Setup Menu - 7. Setup Menu
57
7. SETUP MENU
continued …
All Triggers:
Allows you to ‘Enable’ or ‘Disable’ all trigger options regardless of their settings. For custom installations,
‘RS-232 Ctrl’ defeats the settings and allows external control over all triggers.
Set Trigger 1, 2, 3:
Under each of the four AVM 20 Paths, MAIN (M), ZONE2 (Z2), ZONE3 (Z3), and RECORD (REC), you will notice
that there are 40 available Sources (40 dashes) that could be used to activate that particular trigger.
To set Trigger 1, 2, or 3 to activate according to Source selection, simply enter that trigger’s Control Chart and
replace the ‘–’ beside the desired Source and under the desired Path with a ‘*’.
In the example shown above, TRIGGER 1 will activate whenever MAIN power is turned on. The Trigger1
output will then supply an output of 12 volts with up to 50mA of current.
Note: Changes to the trigger setup do not take effect until the Setup Menu is exited completely, to avoid
unnecessary rapid turning off and on of triggers while changes are being made.
Set IR Inputs:
Allows you to enable or disable the AVM20’s Front IR Receiver and Rear IR Inputs. Being able to do so can
be useful when an IR repeater, connected to the AVM 20, is located in the same room as the AVM 20. In such
a case, the AVM 20 can receive two IR signals for the same command – one from the Remote Control and
one from the repeater. The problem is that rear signal is delayed slightly, and may confuse the IR Receivers’
control circuits. Disabling the Front IR solves this problem.
9.
TRIGGERS / IR / RS-232
a.
ALL TRIGGERS : Disabled
b.
SET TRIGGER 1
c.
SET TRIGGER 2
d.
SET TRIGGER 3
e. SET
IR-INPUTS
f. BAUD
RATE :
19200
g. FLOW
CONTROL :
None
h.
RS-232 TX STATUS : Off
9c. SET TRIGGER 1 SOURCES
MAIN Z2 Z3
REC
a.
POWER ON :
*
–
–
b.
CD :
–
–
–
–
c.
2-Ch :
–
–
–
–
d.
6-Ch :
–
e.
TAPE :
–
–
–
–
f.
FM/AM :
–
–
–
–
g.
DVD :
–
–
–
–
h.
TV :
–
–
–
–
i.
SAT :
–
–
–
–
j.
VCR :
–
–
–
–
k.
AUX :
–
–
–
–