Anthem AVM 20 Setup Menu - 7. Setup Menu
61
7. SETUP MENU
continued …
Example 1: Save User Settings.
Note: FM • AM Tuner presets will also be saved in USER SETTINGS.
• Enter the Setup (section 7.1). Go to ‘11. SAVE/RESTORE SETTINGS’ and press SELECT.
• Upon entering this menu item, “11a. SAVE USER SETTINGS” will be highlighted in red.
• Press SELECT. You will be asked to confirm that you want to over-write current settings.
• Use the
"# buttons and change to ‘Yes’. If you are using a Password (section 7.4.12), you will be
asked for it. Use the 0 – 9 buttons to enter your Password. The On-Screen display message will then
say ‘Saving Successful’, the Front Panel display will say ‘Done!’.
• When finished, press
&' to go to another menu item, or...
• Press BACK to leave the submenu and return to the main menu.
Example 2: Restore Installer Settings.
Note: FM • AM Tuner presets that were saved in INSTALLER SETTINGS will also be restored.
• Enter the Setup (section 7.1). Go to ‘11. SAVE/RESTORE SETTINGS’ and press SELECT.
• Press the
' button until you reach “d. RESTORE INSTALLER SET’NS”.
• Press SELECT. You will be asked to confirm that you want to restore installer settings.
• Use the
"# buttons to change to ‘Yes’ and press SELECT. On-Screen display message will then say
‘Saving Successful’, the Front Panel display will say ‘Done!’.
• When finished, press
&' to go to another menu item, or...
• Press BACK to leave the submenu and return to the main menu.
Example 3: Reload Factory Defaults.
Note: The current time and FM • AM Tuner presets will be retained. Individual speaker level, balance,
bass/treble adjustments (sections 5.6 and 5.7), and Modes (section 5.8) will be reset to +0.0 dB.
• Enter the Setup (section 7.1). Go to ‘11. SAVE/RESTORE SETTINGS’ and press SELECT.
• Press the
' button until you reach “e. RELOAD FACTORY DEFAULTS”.
• Press SELECT. You will be asked to confirm that you want to ‘reload factory settings’.
• Use the
"# buttons to change to ‘Yes’ and press SELECT. On-Screen display message will then say
‘Saving Successful’, the Front Panel display will say ‘Done!’.
• When finished, press
&' to go to another menu item, or...
• Press BACK to leave the submenu and return to the main menu.