Anthem AVM 20 Setup Menu - 7. Setup Menu
58
7. SETUP MENU
continued …
In other situations, the IR signal may find its way to the internally mounted rear IR Receiver through the vents
in the top cover. This could also cause confusion for the AVM 20. If the Rear IR Receivers are not used, simply
disable them to solve any possible problems.
Note: If the AVM 20 suddenly stops responding to Remote Control commands, it may be because the
FRONT IR was accidentally disabled. If this has occurred, use the Front Panel buttons to enter the
Setup – go to menu 9. TRIGGERS/IR/RS-232, then go to SET IR-INPUTS (menu 9.e) and change the
FRONT IR settings to ‘*’ to re-enable.
Baud Rate and Flow Control:
The Baud Rate (adjustable from 1200 to 115200 bps), and Flow Control (‘RTS’, ‘CTS’, or ‘NONE’), allow
configuration of the serial port communication parameters (normally for use by dealer/installers only).
RS-232 TX Status ON Settings:
Echoes front panel and remote control commands, status changes, and control information through the
RS-232 port (normally for use by dealer/installers only).
Example: Activate Trigger1 and 2 when DVD is selected in MAIN.
• Enter the Setup (section 7.1). Go to ‘9. TRIGGERS/IR/RS-232’ and press SELECT.
• Upon entering this menu item, “9a. ALL TRIGGERS: Disabled” will be highlighted in red.
• Use the
"# buttons to change to ‘Enabled’.
• Press the
' button to go to “b. SET TRIGGER 1”.
• Press SELECT.
• Use the
&' buttons to go to ‘DVD’.
• Press SELECT.
• Use the
&' buttons to change the ‘–’ to ‘*’.
• Press BACK twice to leave this submenu.
• Press the
' button to go to “c. SET TRIGGER 2”.
• Press SELECT.
• Use the
&' buttons to go to ‘DVD’.
• Press SELECT.
• Use the
&' buttons to change the ‘–’ to ‘*’.
• Press BACK to leave the submenu and return to the main menu.
9e. SET
IR-INPUTS
MAIN Z2 Z3
a.
FRONT IR :
*
*
*
b.
REAR IR 1 :
*
*
*
c.
REAR IR 2 :
*
*
*
d.
REAR IR 3 :
*
*
*