Anthem AVM 20 Setup Menu - 7. Setup Menu
44
Digital:
When you select Digital and connect the digital output from your source component, you can still use the
analog L/R connections from that same source component to provide Analog input for the other Paths
(ZONE2, ZONE3, RECORD, HPHONE).
Audio/Video-In Format/MAIN also allows for three other adjustments:
• Assign the type of digital connection: For Digital Sources, choose RCA, TOS1, TOS2, TOS3, or XLR.
• Adjust Levels: If Anlg-DSP or Anlg-Dir is selected, you can match Source levels in MAIN to each
other so there are no large changes in volume as you change Sources.
If a source is playing while you adjust the Anlg-DSP Level, you will notice a vertical bar graph to the
left of the dB setting. With the On-Screen display, if this Bar Graph changes from green to pink, you
have gone into an overload condition. Reduce the level until the bar graph changes back to green.
Before making changes or adjustments in this menu, have all connected source components playing
similar music material. Then, as you switch through each highlighted Source, you will hear that
component play. This lets you know that each component is correctly connected to the AVM 20, and it
also allows for easy comparative level adjustments of analog sources.
• Set Source Equalization: For Sources set to Digital or Anlg-DSP, this allows you to preset low and
high frequency levels for the selected Source without affecting other Sources. This is useful for
source components that have frequency irregularities.
Note: The BASS and TREBLE buttons on Front Panel and Remote Control DO NOT affect this menu, but
allow ‘on-the-fly’ adjustment of program material as may be required (see section 5.7).
Example 1: Change SAT Digital Input from ‘RCA’ to ‘Toslink1’ (TOS1).
• Make sure satellite receiver is connected to TOS1 and playing.
• Enter the Setup (section 7.1). Go to “2. AUDIO/VIDEO-IN FORMAT/MAIN” and press SELECT.
• Press the
' button until you reach “h. SAT: Digital RCA”.
• Press SELECT. ‘RCA’ will be highlighted in red.
• Use the
&' buttons to change to ‘TOS1’ (sound will now be heard).
• When finished, press BACK and then &' to go to another Source, or...
• Press BACK twice to leave the submenu and return to the main menu.
7. SETUP MENU
continued …
2k.
SET SOURCE EQUALIZATION
Lo Freq
Hi Freq
a.
CD :
+0.0 dB
+0.0 dB
b.
2-Ch :
+0.0 dB
+0.0 dB
c.
6-Ch :
+0.0 dB
+0.0 dB
d.
TAPE :
+0.0 dB
+0.0 dB
e.
FM :
+0.0 dB
+0.0 dB
f.
AM :
+0.0 dB
+0.0 dB
g.
DVD :
+0.0 dB
+0.0 dB
h.
TV :
+0.0 dB
+0.0 dB
i.
SAT :
+0.0 dB
+0.0 dB
j.
VCR :
+0.0 dB
+0.0 dB
k.
AUX :
+0.0 dB
+0.0 dB