Eatel FiberEdge User Manual - 8300 Back Panel Overview
31
Continued on Next Page
1 Cable In
Connect to the coaxial cable coming from the wall.
2 Cable Out
Connect a coaxial cable to Cable Out to send analog audio and video signals to a
TV or VCR. These signals are SDTV video and stereo audio.
3 Audio Out (L and R) Connect RCA cables to Audio Out to send analog audio signals (left and right) to a
stereo receiver or TV with stereo outputs.
4 Video Out
Connect to video input of a TV or VCR.
5 Digital Audio Output Connect an RCA cable to send a digital audio signal to a surround-sound receiver
or other digital audio device.
6 Secondary Video
Connect to either a VCR for archiving saved content from the 8300HD or to
and Audio Out
another set of inputs (composite) on your HDTV.
7 S-Video Out
Connect an S-Video cable to send an S-Video signal to your TV or VCR. This signal
is standard definition, but higher quality than other SDTV connections.
8 IR
(This connector reserved for future use.)
9 SATA
Connect to an external Serial ATA (SATA) hard disk drive for expanded recording
capability. Please check with EATEL for a list of approved hard drive models for
use with the 8300.
10 AC Outlet
Connect the AC power cord from another device, such as a TV.
11 AC Power Input
Connect the STB to an AC electrical outlet using the cord provided.