Eatel FiberEdge User Manual - Using Power-Save Mode
73
Continued on Next Page
Move the PIP Screen
To move the PIP screen clockwise to a different corner
of the Main screen, press the PIP Move button
.
You can move the PIP screen to any of the four
corners of the Main screen.
Using Power-Save Mode
To maximize the life of your DVR, you should use the power-save mode when your DVR is not in use.
To do this, you must power-down the DVR either using the remote (CBL > Power) or by pressing the
power button on the STB itself. When the DVR enters power-save mode, your TV displays a black
screen if turned on. Note: In power-save mode, the STB is powered-down and the power light turns
off but, because the DVR is still plugged in, all scheduled recordings will still occur.
Between 1:15 a.m. and 6:00 a.m. daily, your DVR
will automatically enter power-save mode unless
you press a button on the remote control or a
button on the DVR STB front panel at least once
every 2 hours.
At 1:10 a.m. the DVR displays the five-minute
warning banner, indicating that the DVR is
about to enter power-save mode. When this
banner appears, do one of the following:
> To allow the DVR to enter Power-Save mode, do nothing when the warning banner appears.
The DVR will automatically power-down. After your DVR powers down, you must press CBL
and then Power on your remote control, or press Power on the front panel of your DVR to start
watching TV again.
> To prevent the DVR from entering Power-Save mode, simply press any button on your remote or
any button on the front panel of the DVR when the warning banner appears. The DVR will not
attempt to enter power-save mode again until another 2 hours of inactivity have passed.