Gardsman CTC-1132 Installation, Programming, Operating - page 11
7
Step 3. After 2 sec, the Control Panel will emit
a long beep, the following prompt
message will be displayed, and
recording can be started.
* N o w R e c o r d i n g *
E
n
d
w i t h
O
k
Step 4. Press OK key to end the message; the
screen will go to Specific Part
Selection menu to allow you to select
a specific part to be recorded.
<
<
N
N
O
O
T
T
E
E
>
>
)
To end your recording at any time,
press key and the message will be
saved as is. The screen returns to
Recording Selection menu.
)
The maximum length of Address
message is 8 sec. When the 8 sec
duration is over, recording will be
stopped automatically. The message
being recorded will be saved.
)
When recording, make sure you are
facing the microphone at the front
within the range of 30 cm.
Recording Specific Alarm Messages
z
If
Rec. Specific is chosen, the specific
alarm message selection menu is
displayed for you to select the desired one.
B
u
r g
l a r M
s g
F
i r e M
s g
P A M s g
E m e r g e n . M s g
S t o p
z
Select a specific message and follow the
same procedure as recording Address
message to record each specific message
respectively.
<
<
N
N
O
O
T
T
E
E
>
>
)
The message length for each specific
message is 3 sec only.
Changing a Message
If for any reason, you want to change any part
of the recorded message, just follow the same
procedure to record a new message for that
part. The new message will overwrite the
previous one.
2.2.3. Test Report
Control unit allows you to test whether
telephone function is working properly or not
with the pre-set telephone numbers.
Step 1: Use (V) or (Λ) cursors to select the
test-call number to test dial. Press OK
key to confirm.
Step 2: Following screen will appear:
D i a l i n g . . . . . . . . .
. . . . . . . . . . . . . . . .
Step 3: Control Unit will dial the number and
play messages starting with address
message and ending with
acknowledgement message.
N o w P l a y i n g :
A d d r e s s M s g
Step 4: Panel will show what messages are
being played. The word prompt will
show the following:
Now Playing:
Address Msg
Emergen. Msg
Fire Msg
Burglar Msg
Ack Msg
The Address Message will be played
first. Followed by the specific
messages. The last Acknowledge
message will be played to the
recipient and to confirm their
reception & open the listen-in by
pressing DTMF (#1) or end the call by
pressing DTMF (#9) or (#0).
Acknowledging with signal 1
The recipient can press 1 to acknowledge
the call and also initiate a One-Way Listen-
In Channel for 2 minutes. This channel
allows the recipient to listen in to what is
happening to the other side of the line.
<
<
I
I
M
M
P
P
O
O
R
R
T
T
A
A
N
N
T
T
N
N
O
O
T
T
E
E
>
>
Address message must be recorded
before the Control Panel can dial out at
an Alarm situation.