Gardsman CTC-1132 Installation, Programming, Operating - page 14
10
To Delete User PIN code
Except User number 1 which is activated by
factory default and can’t be deleted in any way,
User number 2, 3 and 4 PIN code can be
deleted by following the steps below:
Step 1. Move the cursor to the item Pin Code
thenpress OK key, the following
screen will show the status of each
User PIN code:
* 1 ) M R . S M I T H
2 ) M R S . S M I T H
3 ) ¿ ¿ ¿ ¿ ¿ ¿
4 ) . . . . . .
Step 2. Move the cursor to the desired # (2~4)
of programmed user PIN code to be
deleted, thenpress OK key the
following screen is displayed.
D e l e t e
P i n - C o d e ( + O k ) ?
Step 3. Press OK key and the screen returns
to previous one with the deleted User
PIN code marked with ●●●●.
To Edit User PIN code
All 4 User PIN code can be edited freely by the
following steps:
Step 1. Move the cursor to the item Pin Code
thenpress OK key the following
screen will show the status of each
User PIN code:
* 1 ) M R . S M I T H
2 ) M R S . S M I T H
3 ) ¿ ¿ ¿ ¿ ¿ ¿
4 ) . . . . . .
Step 2. Move the cursor to the desired number
(2~4) of programmed user PIN code
to be deactivated/deleted, thenpress
OK key the following screen is
displayed.
D e l e t e
P i n - C o d e ( + O k )
Step 3. Press key, the next screen will ask
you to enter your new PIN code and
repeat it for double confirmation.
Step 4. Follow the same steps as described in
Set your own pin code to edit.
2.3.2. Temporary Code
z
The Temporary Code is used to
arm/disarm the system for a temporary
user and is valid only once per Arming and
once per Disarming. Afterwards, the
Temporary Code is automatically erased
and needs to be reset for a new Temporary
user .
z
The Temp. Code consists of 4 digits and is
not activated as default by the factory.
To Set Temporary Code
Step 1. Use the arrow keys to select Temp.
Code and press OK key
E n t e r N
e w
C
o d e
. . . .
Step 2. You can key in your preferred 4-digit
number and then press OK key
R e p e a t N e w C o d e
. . . .
Step 3. You are prompted to re-enter the same
code again and press OK key
If the code is correct, the screen
changes to the following:
* L a t c h . R p t . O f f
L a t c h . R p t . O n
You are requested to choose to have
all arm/disarm actions of the user to be
reported to the Central Monitoring
Station or not.
Step 4. Press S&T keys to select your option
and press OK key. The screen returns
to General Setting menu, setting the
Temporary code is completed.
<
<
N
N
O
O
T
T
E
E
>
>
)
There is no User Naming feature for
Temp. Code.