Gardsman CTC-1132 Installation, Programming, Operating - 3.8. Stop The Alarm and
33
3.8. Stop the Alarm and
Alarm Display
During any alarm, the Control Panel wil sound
its siren and report to the Phone number
programmed previously. The display will show
as below:
A L A R M ! A L A R M !
A L A R M ! A L A R M !
3.8.1. Stopping the Alarm
During an alarm, to stop the siren and clear
display:
Step 1. Key in your PIN code, followed by OK
key.
<
<
N
N
O
O
T
T
E
E
>
>
)
if you press any key other than the
first digit of your PIN code, the screen
will prompt you to enter your PIN code.
Step 2. If the PIN code is correct, then the
alarm sounding will be stopped.
If the alarm is stopped before reporting
process begins:
Step 3A. The screen will show you which
device that triggered the alarm with
its zone number displayed:
A l a r m S t a r t e d B y
0 1 ). I R H a l l w a y
Step 4A. Press OK key.
Step 5A. If there are more than one alarm
events have been raised, the
Control Panel continues displaying
the 2nd alarm event with 02). Stating
at the beginning of the 2nd line.
Step 6A. Repeat pressing further keys until all
the alarm events are displayed
thoroughly then the display will show:
S y s t e m r e a c h e d
N o n e
Step 7A. Press OK key, the display returns to
Alarm off.
<
<
N
N
O
O
T
T
E
E
>
>
)
Press
key or no key is pressed
within 5 sec. the screen returns to 1
st
device display. You can repeat from
the beginning to view the alarm event
one more time.
)
No alarm reporting will be made.
However one OPEN report by the
user will be reported.
If the alarm is stopped before reporting
is finished:
Step 3B. The screen will show you which
device triggered the alarm with its
zone number displayed:
A l a r m S t a r t e d B y
0 1 ). I R H a l l w a y
Step 4B. Press OK key
Step 5B. If there are more than one alarm
events have been raised, the
Control Panel continues displaying
the 2nd alarm event with 02).
Starting at the beginning of the 2nd
line.
Step 6B. Repeat pressing further keys until all
the alarm events are displayed
thoroughly then the display will show:
S y s t e m r e a c h e d
N o n e
Step 7B. Press OK, the display returns to
Alarm off.
If the alarm is stopped after reporting
has been finished,
Step 3C. The device that triggered the alarm
with its zone number is displayed.
A l a r m S t a r t e d b y
0 1 ). I R H a l l w a y
z
Proceed to display the alarms and clear
the alarm displays as specified in Step 4A
~ Step 6A in previous section.
Step 4C. After all the alarm events are cleared,
then the display will show:
S y s t e m r e a c h e d
2 6 9 4 0 6 6 7
Step 5C. Press OK key, the display returns to
Alarm off.