Gardsman CTC-1132 Installation, Programming, Operating - 1.2. Insert Gsm Sim Card
2
1.2. Insert GSM SIM Card
CTC-1132 Control Panel features built-in GSM
communication facility to make message
reporting to the phone numbers pre-
programmed within the system.
To Insert your SIM card:
The GSM component is situated inside the
Power Supply compartment as pointed out by
the arrow below:
SIM CARD
z
Unlock the SIM card base by sliding the
cover toward OPEN-backward direction.
z
Spring open the SIM card slot and insert
your new SIM card.
z
Replace the SIM slot onto the base lightly.
z
Remember to lock the SIM card base by
sliding the cover toward LOCK-forward
direction.
<
<
I
I
M
M
P
P
O
O
R
R
T
T
A
A
N
N
T
T
N
N
O
O
T
T
E
E
>
>
Be aware to only insert or remove SIM card
when the Control Panel is completely
depleted of any power residual.
1.3. The Power Supply
An AC power adapter is required to connect to
a wall outlet. Be sure only to use an adapter
with the appropriate AC voltage rating to
prevent component damage. A DC 9V output
and 500mA adapter is generally used to power
the Control Panel.
Rechargeable Battery
z
In addition to the adapter, there is a
rechargeable battery inside the
Control Panel that serves as a back
up in case of a power failure.
z
The battery used is a 7.2V 600mAH
Ni-mH rechargeable battery pack.
z
During normal operation, the AC
power adapter is used to supply
power to the Control Panel and at the
same time recharge the battery.
z
When the battery is fully charged, it
can provide back-up power for a
period of at least 8 hours. It takes
approximately 48 hours to fully charge
the battery.
<
<
N
N
O
O
T
T
E
E
>
>
)
The CTC-1132 is equipped with
Backlit LCD display to add the
convenience of easy operation when
in dark. However, when AC power is
missing and for the reason of
conservation of rechargeable battery,
Backlit feature will be disabled until
the AC power is supplied again.
1.4. How to install the Control
Panel
Locating a suitable position for the
Control Panel
z
The Control Panel requires mains power
and a constant telephone connection,
z
The Control Panel should be easily
accessible,
z
The Control Panel should not be placed in
a damp place, such as a bathroom.
z
The Control Panel should not be placed
close to any heat source, such as
microwave ovens, which can reduce
signal srength.
z
The Control Panel should not be located
alongside other radio transmitting devices
such as mobile phones, cordless phone or
wireless computer network (WiFi) devices.
Impontant:
When drilling into a wall, ensure
that there are no hidden cables or pipes.
Mounting the Control Panel
The Control Panel can be mounted on the wall
or wherever desired. Ensure the Control Panel
is fitted at approximately chest height where
the display can be easily seen and the keypad
convenient to operate.