Gardsman CTC-1132 Installation, Programming, Operating - page 20
16
2.4.9. Interference
This is for you to decide whether the Control
Panel should detect signal jamming or not.
D e t e c t i o n O f f
D e t e c t i o n O n
z
Detection Off is set as factory default.
<
<
N
N
O
O
T
T
E
E
>
>
)
When the Detection On is selected,
whenever the signal jamming period
lasted longer than 30 secondas, this
fault event will be logged, reported to
the Central Monitoring Station and
displayed on the LCD to warn the user.
)
When the Dectection Off is selected,
Control Panel will not check
interference status.
2.4.10. Remote Controller Entry Enable
Turn on and off the Remote Controller disarm
function.
R
C
E
n
t E
O
f f
R
C
E
n
t E
O
n
z
Remote Controller Entry Enable off is
set as factory default.
<
<
N
N
O
O
T
T
E
E
>
>
)
When the Remote Controller Entry
Enable is set to Off it will not be
possible to disarm the Control Panel
when the system is fully armed unless
an entry point device is activated first.
This feature is used to ensure that the
system cannot be disarmed with a
stolen Remote Control without
unlocking a door first.
)
When the Remote Controller Entry
Enable is set to On, the Remote
Controller can Arm and Disarm the
Control Panel as normal without
activating an entry point first.
2.4.11. Mobility
This is to disable or enable the Mobility Timer
with selected countdown period. Options
available are Disable, 4 hours, 8 hours and
12 hours.
If the Mobility Timer is enabled, it will count
down the pre-programmed time length. When
the timer times out without being reset, a report
will be made to the Programmed phone
numbers.
D i s a b l e
4 H r s
8 H r s
1 2 H r s
z
Disable is set as factory default.
<
<
N
N
O
O
T
T
E
E
>
>
)
When the Mobility is set with a specified
timer, the Control Panel will report to the
Programmed phone numbers when the
timer runs out unless one of the following
actions occurred in advance to reset the
timer:
In Home mode: whenever any Home
Omit DC, IR is triggered, or whenever
any of the keys of the Control Panel is
pressed
In Disarm mode: whenever any of the
DC or IR (except 24 Hr, Fire, Medical
Emergency and Water) is triggered,
or whenever any of the keys of the
Control Panel is pressed
)
When the system is set to Away Arm, the
timer automatically stops. When the
system enters Home Arm or Disarm
mode, the timer automatically starts again.
2.4.12. Tamper Alarm
This option is to choose if the siren will sound
alarm when the Tamper is triggered.
A w a y A r m O n l y
N o r m a l V
z
Away Arm Only is set as factory default.
<
<
N
N
O
O
T
T
E
E
>
>
)
Away Arm Only means, when tamper
is triggered under Away arm mode,
Control Panel raises a local alarm and
sends report to the monitoring center.
While under Home or Alarm off modes,
the siren does not sound nor any
report will be sent.