Gardsman CTC-1132 Installation, Programming, Operating - 1.5. Two Level Passwords
3
z
Using the 2 holes of the Wall Mounting
Cross Bracket as a template, mark off the
holes’ positions.
z
Drill 2 holes and insert the wall plugs if
fixing into plaster or brick.
z
Screw the base to the wall
z
Hook the Control unit onto the Wall
Mounting Cross Bracket (holding the unit
with the front facing you).
1.5. Two level passwords
In order to provide highest security in operating
the system, CTC-1132 offers 2 levels of
authorization. When you want to program the
system, you have to enter Personal PIN Code
and Master Code.
PIN Code
z
There are a total of 4 User PIN Codes
per each system. The PIN Code is the
1st level of password. When the display
panel asks you to key in Enter Code or
P-Code, please enter your User PIN
Code.
z
1234 is set as default User 1 PIN Code
by the factory.
z
User 2~4 PIN codes are deactivated by
factory default.
Master Code
z
The Master Code has the authorization to
enter Programming mode. When the
display panel asks you to key in M-Code,
please enter your Master Code.
z
1111 is set as default Master Code by the
factory.
<
<
N
N
O
O
T
T
E
E
>
>
)
Any of the Codes can NOT be set the
same. If you set the same number, the
display panel will show: Code is use,
select another to prompt the user to
choose differently.
1.6. Getting Started
Step 1. Find a suitable location for the Control
Panel to be installed.
Step 2. Apply the AC Power. You will hear a
long beep. Alarm On will be displayed
on the first line and 00:01 01 Jan
displayed on the second line of the
screen indicating the system is in
Away Mode (this is the default Mode)
Step 3. Press 1 key on the keypad, the display
will show.
E n t e r C
o
d
e
¿ . . .
Step 4. Key in the remaining 234 (default User
1 PIN code, 1234) within 30 sec.
Step 5. Press OK key. You will hear 2 short
beeps and the display will show.
A l a r m
O f f
0 0 : 0 1
0 1 J a n
The system is now in Disarmed Mode.
<
<
N
N
O
O
T
T
E
E
>
>
)
In Step 4, press
(cancel) key will
clear a previously entered code.
)
OK key confirming the entered PIN
code should be pressed within 30 sec.
Otherwise, the display will go back to
Alarm On and the system remains
armed.
)
During entering PIN code, if more than
20 keys (including OK & keys) were
pressed without a valid PIN code
strings, it will inhibit further key
presses for 1 minute.
)
In Step3, if you press a key other than
numeric keys, the display will remain
the same requesting you to key in
1234 (default PIN code) and then
press OK key.
)
The Control Panel has Screen Save
function. The Alarm off message will
be displayed for 180 sec. only.
Afterwards only current date & time is
displayed on the second row line.
Step 6. Please wait for 2 to 3 minutes for the
system to read it status. If the yellow
LED turns on, it indicates that there is
a fault. Please refer to section 3.12.
faulty Situatiions to slove the fault.