Gardsman CTC-1132 Installation, Programming, Operating - 3.4. Disarm (Alarm Off) Mode
30
<
<
N
N
O
O
T
T
E
E
>
>
)
Any time pressing key followed by
PIN Code and OK key, the screen
returns to Alarm Off
)
The Fault DSP screen has a time-out
for 5 minutes. It will automatically exit
and return to Alarm Off screen after 5
minutes.
)
If a sensor is by-passed (Please see
section Partial Arm mode, the fault
condition of that sensor will not be
checked.
)
If a sensor tampered or out-of-order
occurs, you can temporarily by-pass it
or permanently remove it.
Arming with Door Opened
z
While you arm the system, if any door was
detected to be open, the Control Panel will
also sound a ding-dong warning sound to
indicate arming is prohibited. The
message Fault DSP is displayed in the
middle of the top display row and
alternates at 2-second intervals with the
sensor name that is being triggered.
z
At this moment, you can close the opened
door, after which the fault display will be
cleared automatically and the screen
returns to Alarm off. You then can arm
the system again.
z
However, if you want to put the system
into Arm mode with the opened door, it is
still possible by following the Steps
described above to execute Forced
Arming.
3.4. Disarm (Alarm off) mode
Disarming the system
To disarm the system
If the system is in either the Away Arm mode or
Home Arm mode (Alarm ON), enter your pin
Code and press OK key. If the PIN code is
correct, the Control Panel will sound 2 short
beeps and return to Disarmed mode. The
screen will show.
A l a r m
O
f f
0 6 : 4 3 0 1 J a n
<
<
N
N
O
O
T
T
E
E
>
>
)
When the system is Home Armed,
pressing the DISARM button on the
Remote Controller will disarm the
system.
)
When the system is Away Armed,
pressing the DISARM button on the
Remote Controller can disarm the
sytem when either an Entry device
has been triggered, or when the
Remote Controller Entry Enable has
been set to ON.
3.5. Home Arm Mode
The Home mode allows the home to be Armed
so that no one can get inside without first
Disarming the system, yet the person already
inside the house can move freely without self
triggering the alarm.
<
<
N
N
O
O
T
T
E
E
>
>
)
You can enter the HOME mode only
when the system is in DISARMED
mode.
3.5.1. Entering Home Mode
Step 1. When the system is in Disarmed mode,
key in your Pin Code then press OK
key.
Step 2. Press T key to move the cursor
down to select Home Arm.
Step 3. Press OK and the screen will display.
T i m e T
o
E
x i t
3 0 s e c