Jacuzzi J - 355 Owner's Manual - J-300 Series
J-300 Series
10.0 Operating Instructions
The spa control system has automatic functions that operate upon start-up and
normal operation to protect the system. Upon power up, the readout displays
the following information:
1. Control panel displays current software release
(e.g. 3.56), then;
2. Control panel displays “888” and all indicator LEDs are
lit, permitting visual inspection of all display segments
and indicator lights for proper operation.
3. After the initial start-up sequence ends, the actual water
temperature is displayed. If water temperature at this
time is less then the factory default temperature setting
of 100°F (38°C) and the spa is set to either standard
filtration/heating mode (page
and run until the water temperature rises to the factory
setting, then turn off.
Note: It is common for the heater
to turn on after the spa is first filled because tap water is
often very cold.
10.1 Setting Water Temperature
The spa’s thermostat provides optimum control of water
temperature. The temperature set point (set temperature) can be
adjusted from 65-104°F (18-40°C). To raise the set temperature,
press the WARMER (
) button. To lower the set temperature,
press the COOLER (
) button.
Note: The first press of either WARMER (
)
or COOLER (
) button displays the set temperature.
10.2 Activate Jet Pumps
The control panel JETS 1 button activates jets pump 1. The first
press activates low speed, the second press activates high speed,
and the third press shuts jets pump 1 off. The JETS 2 button
activates jets pump 2. The first press activates high speed, the
second press turns jets pump 2 off. When manuallly activated, either pump will
automatically turn off after 20 minutes.
10.3 Light On/Off Button
Pressing this button activates the logo, footwell IX Jet light and
waterfall lights in sequence as follows: high - medium - low -
off.
Note: Lights automatically turn off after 2 hours.
1.
2.
3.
1.
2.
3.
21