Jenn-Air JMD2124WS Technical Education - Warning
4-2
4. Close Drawer and pull the unit out from
opening and unplug the power
supply cord.
5. Remove top cover, see figure 2.
1. Unplug microwave drawer or disconnect
power.
2. Before removing Microwave Drawer,
take measures to protect the Drawer
trim by either removing the trim or
by letting the trim over hang off flat
protected surface (see figure 1).
3. Open the Drawer to access the 4
mounting screws holding the unit on to
the wall or cabinet opening,
see figure 1.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
Figure 1
Figure 2
Top Cover
Screws
6. Remove air cover from back of unit, then
both side panels. (figures 3 & 4).
Figure 3
Figure 4
Air Cover
Side Panel
Screws
(4) Mounting
Screws (1 is hidden
by drawer) in this view
(Remove both side panels, right side is shown)
ACCESSING INTERNAL COMPONENTS
Trim