Jenn-Air JMD2124WS Technical Education - Warning
4-19
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
1. Unplug microwave drawer or disconnect
power.
2. Discharge the high voltage
capacitor terminals with a 20,000 W
2 watt resistor to chassis ground.
3. Follow the “Removing the Drawer
Assembly on page 4-8.
4. Pull the center slide rail (rack gear)
as far as it will go, see figure 1.
REMOVING THE AUTO DRAWER GEAR
REMOVING THE RACK GEAR
Three Screws
Figure 1
Center Slide Rail
Clip
Rack Gear
5. Disengage the clip on the slide rail,
see figure 2 and 2A.
6. Pull slide rail straight out to remove.
7. Remove the (3) screws holding the
rack gear to the bottom slide rail,
see figure 3.
Figure 2
Figure 2A
Figure 3
Bottom side of center slide rail
Top side of center slide rail