Jenn-Air JMD2124WS Technical Education - Warning
4-18
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
1. Unplug microwave drawer or disconnect
power.
2. Remove the microwave drawer from the
cabinet as outlined in steps 1-4 of
Accessing Internal Components (see
page 4-2 for the procedure).
3. Remove the top and right side panels as
outlined in the steps Accessing Internal
Components (see page 4-2 and 4-3 for
the procedure).
4. Discharge the high voltage
capacitor terminals with a 20,000 W
2 watt resistor to chassis ground.
9. Disengage (pull) Auto Drawer Gear
from rack gear and slide to the right
(toward the rear), then turn motor 90° and
slip out along rear of drawer, see figure 3.
10. Tilt Auto Gear Motor 20° to remove
the assembly.
REMOVING THE AUTO DRAWER GEAR
Bottom Cover
Clearance Hole in
Bottom Cover for
Screwdriver
Figure 1a
Figure 1b
Figure 2
Figure 3
Figure 4
5. Open the drawer and keep it open.
6. Unhook wiring to Auto Drawer Gear.
7. Remove bottom screw below Auto
Drawer Gear, see figure 1a and 1b.
Bottom Cover
Base Plate
Screwdriver
8. Remove the (4) screws holding the auto
drawer gear to the bottom cavity angle,
see figure 2.
Four Screws
Slide to Back
Turn 90°
Tilt 20°