Karassn KS-200B Series User Manual - page 10
100-Zone Wireless Alarm System
-
9
-
alarm signal. After which, it enters arm state automatically.
Functions: Infrared Detecting, Control By Remote Controller, Transmit Wirelessly.
5.5 KS-200BTI Wireless PIR Detector
Base on KS-200ATI, KS-200BTI increase functions to alarm on the spot, it sends
alarm signal for 5 seconds when triggered, at the same time, it make alarm sound on
the spot for 30 seconds.
Functions: Infrared Detecting, Alarm On The Spot, Control By Remote Controller,
Transmit Wirelessly.
6. Interfaces Instruction
Interfaces Instruction Of KS-200B Main Unit
V+ Terminal -------- Anode of DC 12V—13.8V output.
C Terminal -------- Cathode of DC 12V—13.8V output.
DC Input --------- If build-in backup battery has been selected, it is not need to
connect with outer power.
Alarm Horn --------- Active alarm horn is adopted, which will not affect the
operation of built-in speaker in alarm host. The horn is optional according to
specific requirements.
7. System Installation
7.1 Basic Requirements Of System Installation
(1)During installation, suitable types and models of detectors should be adopted
according to the user’s requirements on defense areas.
(2)The installation location, angle and height of detector are determined
3
PU S E
PU S E
3
C
V+ V+
12V 1.2Ah
100-Zone Wireless Alarm System
-
16
-
Well connect alarm host according to the charter of “ Interface Instruction”. Pick
up telephone receiver and operate as following:
Press # # # -------- It will make a short “beep” sound, which means system has
entered setup state. Press AAAAAA# ------ It means enter the password and
confirm it.
“AAAAAA” stands for password. The original password is “000000”. There will
be a short “beep” sound if the password is correct. Then you can go on the next
operations. Or it will exit the setup state. The password is modifiable. To modify
it, please refer to the “ password modification” charter.
Note
1
、
After press # # #, the outside line will be cut off. The power of telephone is
provided by alarm host. There should be no dialing tone and other voice signals.
Or it shows the outside line still be connected, and should press again or change
the telephone set.
2
、
After press # # #, if there are rapid “beep---beep---”sound. Usually, it is
because that the extension socket and line socket are wrongly connected. And
cause alarm because of line cut-off.
3
、
If no any operations within 20 seconds in setup state, the system will
automatically exit.
Note:
All the following operations should be done in setup state. And press 0 #
0 # to exit when finished.
(1)How To Set Alarm When Telephone Line Short Circuit Or Open Circuit
Press 6# to open the function to test line short circuit and open circuit.
Press 7# to close the function to test line short circuit and open circuit.
It is recommended to open this function, it will make urgently “Beep, Beep”
sound when it test telephone line short circuit or open circuit.
(2) Password Modification
Press 9 # AAAAAA # BBBBBB # BBBBBB #.
The “AAAAAA” is original password, the ex-factory state is “000000”. “BBBBBB”
is new password. After password is modified, the original password will be invalid.
If you want to program again you should enter the new password.
The users should take care of their password. If the password is lost, please contact
the agent to ask for help.
(3)How To Set Inform Telephone Number