Karcher K 2.110 M Operator's Manual - Assembly Instructions
4
Water Supply (Cold Water Only)
• Water hose must be at least 3/4 inch in
diameter.
• Flow rate of water supply must not fall
below 2.5 GPM (gallons per minute).
• Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
IMPORTANT PRECAUTIONS – continued
• The water supply temperature must not
exceed 104°F/40°C.
• Never use the pressure washer to draw in
water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.
• Always prevent debris from being drawn
into the unit by using a clean water source.
ASSEMBLY INSTRUCTIONS
Step 1
Assemble the mobile
adaptor by aligning
the four holes to the
machine. Tighten
each of the four short
screws provided.
Step 4
Assemble the handle
by aligning the holes
to the handle posts.
Insert two of the long
screws and tighten.
Step 2
Slide the two handle
posts into the mobile
adaptor and line up
the holes. Insert two
of the long screws
and tighten.
Step 3
Insert wheels into side
holes of the mobile
adaptor and snap into
place.
Step 6
Place the filter end of
detergent suction tube
into the detergent
container.
Step 5
Assemble the
detergent container.
Step 7
Pull out the locking slide
from the right side of the
trigger gun handle.
Insert the small end of
the high pressure hose
into place.
Push the locking slide
back into the trigger gun
to lock the hose in
position.