Karcher K 2.110 M Operator's Manual - Cleaning Tips
9
Deck Cleaning
(with or without detergent)
Pre-rinse deck and surrounding area with fresh
water. If using Kärcher Deck & Patio Cleaner,
place detergent suction tube directly into
cleaning solution and apply to surface at low
pressure. For best results, limit your work area
to smaller sections of approximately 25 square
feet. Allow Kärcher Deck & Patio Cleaner to
remain on surface 1-3 minutes. Do not allow
detergent to dry on surface. Rinse at high
pressure in a long sweeping motion keeping
the spray nozzle approximately 3-6 inches
from the cleaning surface. Always clean from
top to bottom and from left to right. When
moving on to a new section of the cleaning
surface, be sure to overlap the previous
section to eliminate stop marks and ensure a
more even cleaning result.
Caution: Do not use Dirtblaster spray wand
on wood surface as it may cause damage.
House Siding
(with or without detergent)
Pre-rinse cleaning surface with fresh water. If
using Kärcher Exterior House Cleaner, place
detergent suction tube directly into cleaning
solution and apply to surface at low pressure
(for best results, limit your work area to
sections of approximately 6 feet and always
apply detergent from bottom to top). Allow
Exterior House Cleaner to remain on surface
1-3 minutes. Do not allow detergent to dry on
surface, if surface appears to be drying, simply
wet down surface with fresh water. If needed,
use special Wash Brush Attachment to remove
stubborn dirt. Rinse at high pressure from top
to bottom in an even sweeping motion keeping
the spray nozzle approximately 6 inches from
the cleaning surface.
Caution: Do not use Dirtblaster spray wand
on siding as it may cause damage.
Cement Patios, Brick & Stone
(with or without detergent)
Pre-rinse cleaning surface with fresh water. If
using Kärcher Deck & Patio Cleaner, place
detergent suction tube directly into cleaning
solution and apply to surface at low pressure.
For best results, limit your work area to
smaller sections of approximately 25 square
feet. Allow Kärcher All Purpose Cleaner to
remain on surface 1-3 minutes. Do not allow
detergent to dry on surface. Rinse at high
pressure in a sweeping motion keeping the
spray nozzle approximately 3-6 inches from
the cleaning surface. Always clean from top to
bottom and from left to right. For removing
extremely stubborn stains, use Dirtblaster
Spray Wand.
Cars, Boats & Motorcycles
(with or without detergent)
Pre-rinse vehicle with fresh water. If using
Kärcher All Purpose & Vehicle Cleaner, place
detergent suction tube directly into cleaning
solution and apply to surface at low pressure.
For best results, clean one side of vehicle at a
time and always apply detergent from bottom
to top, do not allow detergent to dry on
surface. If needed, use special Wash Brush
Attachment to remove stubborn dirt. Rinse at
high pressure in a sweeping motion keeping
the spray nozzle approximately 6-8 inches
from the cleaning surface (distance should
increase when rinsing pin-striping or other
sensitive surfaces). Always clean from top to
bottom and from left to right. For best results,
wipe surface dry with a chamois or soft dry
cloth.
Caution: Do not use Dirtblaster spray wand
on vehicles as it may “cause damage.
CLEANING TIPS
CARE AND MAINTENANCE INSTRUCTIONS
Cleaning the water inlet filter
Pull out the water inlet filter with flat-nose
pliers and rinse out in warm water.
Maintenance
The unit is maintenance-free.