La Marzocco linea mini Operating Manual - page 9
EN
9
Note:
• Minimum room
temperature:
5°C/41°F
• Maximum room
temperature:
32°C/89°F
• The weighted sound pressure
level of the machine is
lower than 70dBA.
Espresso machine installation, linea mini
1) Fill water reservoir with potable water.
Once the espresso machine has been
unpackaged, placed on a hard surface.
Remove the drain tray and slide the water
reservoir until the water reservoir fill cover
is accessible. Remove the cover and fill
water reservoir with potable water. Replace
the fill cover and slide the water reservoir
to the operating position and replace the
drain tray. In order to connect the machine
up to the water mains proceed according
to the indications given in the Installation
Guide and in compliance with any local/
national safety standards of the location in
which the machine is being installed.
To guarantee a correct and safe functioning
of the machine and to maintain an adequate
performance level and a high quality of the
beverages being brewed it is important
that the incoming water be of a hardness
greater than 9°f (90ppm, 5°d) and less
than 15°f (150ppm, 8.4°d), pH should be
between 6.5 and 8.5 and the quantity of
chlorides be less than 50mg/l . Respecting
these values allows the machine to operate
at maximum efficiency. If these parameters
are not present, a specific filtration device
should be installed, while always adhering
to the local national standards in place
regarding potable water.
2) Connect espresso machine to power supply.
Connect the espresso machine to a power
supply that is rated in accordance with the
serial plate on the espresso machine.
3) Filling the boilers with water.
Complete the following steps to properly
fill the boiler tanks:
Steam boiler:
Turn the main switch to
position “1”, the steam boiler will then
automatically fill to a predetermined
level. When the correct water level in the
steam boiler is reached, the machine will
automatically stop filling.
NOTE: It may be necessary to re-fill the water
reservoir during this process.
Integrated brew group:
The water flows
inside the Integrated brew group directly
when the water pump is activated. When
the linea mini is turned on the electronics
will activate the water pump to fill both
boilers.
4. Installation
WARNING
The coffee machine must be
placed in a horizontal position on
a counter higher than 90 cm from
the ground.
WARNING
The expansion valve can discharge
water as hot as 200°F / 93°C.
Adequate protection for handling
this component is needed before
attempting to adjust.
WARNING
This machine is not suitable for
outdoor use.