LabStyle Dario User Manual - page 36
36
4. Insert a sterile lancet and make sure that it is firmly in place.
It is recommenced to use LabStyle Innovation™ (30G).
If the lancet does not click into place or the lancet holder does not
hold the lancet properly, insert another sterile lancet.
If the problem persists, it may be necessary to replace your Dario™
housing. Contact Customer Support at www.mydario.com.
5. Carefully twist off the lancet cap as shown above. Make sure not to bend the
lancet needle.
6. If necessary, set the depth of the lancing device. For additional information, see
16.
7. Replace the lancing device cover by sliding it into place until it clicks. Be careful
not to touch or bend the lancet.
STEP TWO - REMOVING THE GLUCOSE METER FROM THE HOUSING
Before starting the testing procedure, you should remove the meter from the
housing.
The meter is stored in the housing when not in use.
❖
To remove the meter from the housing:
1. Hold the housing so that the ridged orange panel is close to you and the end
with the lancing device is facing away from you.