Lanier R/C MARINER 40 MK II ARF Instruction Manual - Pushrod Installation
10
8.
Deflect the rudder to full travel in one direction
and make sure the rudder is tight against the
fin.
Apply one drop of thin CA to each hinge.
Turn the plane over and repeat for the other
side of the rudder.
3.
Repeat step 2 for the elevator pushrod and
control horn.
7.
Place 2 hinges in the rudder half way.
Mount the rudder to the fin.
Pushrod Installation
1.
Collect the following parts:
(2) Nylon swivel keepers
(2) 20” Long Pushrod Wire
2.
Insert the pushrod into the tube in the fuse-
lage.
Make a 1/4” bend at the end of the pushrod
and place it in the control horn.
Place a swivel keeper on the end of the
pushrod.
2.
Mount the elevator and rudder servo as
shown above.
Attach the EZ connectors to the servo arms
the same way you did the aileron servos.
Insert the pushrod wires through the EZ con-
nectors and mount the two servo arms to the
top of the servos.
Cut off the excess pushrod wire.
3.
Plug the elevator and rudder servos into your
receiver.
Attach the “Y” harness to the receiver in the
aileron channel.
Plug in the speed control.
Cut foam and wrap around the receiver.
4.
Put the receiver wrapped in foam in front of
the servos.
Radio Installation
1.
Collect the following parts:
(1) Fuselage
(2) Micro Servos with Hardware (Not Included)
(1) Micro Receiver (Not Included)
(1) Servo “Y” Harness (Not Included)
(2) Mini- Pushrod Connectors