Lanier R/C MARINER 40 MK II ARF Instruction Manual - Decal Locations
Note:
We flew the Fokker DVII ARF with a Ultra Fly
30/29 motor and gear box.. This motor
worked well
Caution:
Too much speed will cause flutter on the
control surfaces which can cause structural
failure in the airframe.
WE DO NOT WARRANTY FOR FLUTTER.
Study the kit box top for decal location
1.
Using glass cleaner and a soft cloth, clean the
model surface thoroughly before applying
decal's.
Cut the decal sheets apart in sections, as
needed.
Peel the backing off the decal and apply the
decal to the location desired.
Decal Locations
15
Control Set Up
Turn on your transmitter and plug in the receiver battery. Center all the control surfaces (rudder, ele-
vator & aileron). If required by your speed control this is the time to program it for your use.
Control Travel
Aileron up / down 1/2”
Elevator up / down 3/4”
Rudder right / left 1”
You will want to adjust these throws to suit your flying abilities. The throws given are starting
throws.
Balancing
Balance the Fokker DVII at 1-1/2” back from the leading edge of the bottom
wing balanced upside down. You can also pick the plane up where the rear
cabane strut attaches to top wing balanced upright.