Lanier R/C MARINER 40 MK II ARF Instruction Manual - Fin & Rudder Installation
9
3.
Insert the fin in the notch in the rear of the
fuselage and align the forward edge in the
center of the fuselage.
Make a mark along the side of the fin on both
sides of the stab.
Fin & Rudder Installation
1.
Collect the following parts:
(1) Fuselage With Stabilizer
(2) Fin & Rudder
(2) Mini CA Hinges
(1) Nylon Control Horn
(1) Long Pushrod Wire
(1) Tail skid
2.
Insert the tail skid into the notch in the bottom
of the fuselage and glue in place.
5.
Glue the fin into the fuselage using epoxy.
4.
Being very careful, remove the covering off
the stab between the lines. Stay 1/16” inside
the lines and don’t cut into the wood.
Note:
The elevators are omitted from the
photo for clarity but they must be installed
first because the joiner wire must go behind
the fin post.
remove covering
6.
Place a drop of glue on the control horn and
insert the rudder control horn in the left side
rudder holes.
Insert the back plate onto the control horn pins
sticking out the other side of the rudder.
Place a drop of glue on the pins to hold the
back plate in place.