Lanier R/C MARINER 40 MK II ARF Instruction Manual - Installing Stabilizer
Other manuals for MARINER 40 MK II ARF:
Assembly Instructions Manual, Assembly Instructions Manual, Owner's Manual, Instruction Manual, Assembly Manual, User Manual
Manual is about: Stinger II .46 ARF
of
15
7
Installing stabilizer
1.
Collect the following parts:
(1) Fuselage
(1) Stabilizer
(1) Bottom wing
(2) #4 x 3/4” screws
(2) #4 flat washers
2.
Mount the bottom wing to the fuselage using
the two #4 x 3/4” bolts and flat washers.
4.
Install the wheel on the axle and secure with
the wheel collar.
A
A
B
B
3.
Set the stab in place on the fuselage and
make sure it is centered. Dimension A should
be the same on both sides and B should be
the same on both sides.
When satisfied with the alignment, make a
pencil mark on the bottom of the stab along
the edge of the fuselage.
4.
Remove the stab and carefully remove the
covering staying 1/8” inside the line you
marked on the bottom of the stab. Be careful
not to cut into the wood, just the covering.
Realign the stab on the fuselage.