Lanier R/C MARINER 40 MK II ARF Instruction Manual - Elevator Installation
8
Look down the length of the fuselage and
check that the stabilizer is parallel to the wing.
If it is not then shim the low side till they are
parallel.
When satisfied then glue the stabilizer in place
using 5 minuet epoxy. Make sure the stabiliz-
er remains both perpendicular and parallel to
the wing and fuselage while the epoxy dries.
Elevator Installation
1.
Collect the following parts:
(1) Fuselage With Stabilizer
(2) Elevators
(4) Mini CA Hinges
(1) Wire Elevator Joiner
(1) nylon control horn
3.
Insert 2 hinges half way into each elevator
Place the the wire elevator joiner in the eleva-
tor. Make sure the elevators will lie flat on the
table, if not bend wire till they do.
Slide the elevator hinges into the stabilizer.
4.
Make sure the elevator is pushed up tight
against the stabilizer and the end of the eleva-
tor is even with the end of the stabilizer.
5.
When satisfied with the fit, remove from plane
and glue the elevator joiner wire into the ele-
vators using epoxy.
2.
Locate the pre-drilled control hole holes in the
right side elevator. .
Place glue on the control horn pins and insert
them in the holes.
Install the plate on the pins on the top side and
glue.
6.
Reinstall the elevators and glue the hinges in
place using thin CA