Lanier R/C MARINER 40 MK II ARF Instruction Manual - Aileron Control Horns
5
Aileron Control Horns
1.
Gather the following items:
(2) Small Control Horns
(2) Wing
(2) Short pushrods
(2) EZ Connectors With Hardware
(2) Swivel Keeper
2.
Cut the back plate off the side of the control
horn.
3.
Locate the pre-drilled control hole holes in the
aileron.
Place glue on the control horn pins and insert
them in the holes.
Because of the thickness of the aileron, the plate
will not be used on the top surface.
4.
Mount the EZ connector hardware on the
aileron servo arm.
5.
Find the small aileron pushrod wire.
Make a 90º bend (or a "z" bend, if preferred)
1/4” from the end of the wire
Insert the wire into the control horn.
Secure the wire with a nylon swivel keeper.
6.
Insert the other end of the push rod through
the EZ connector.
Mount your servo arm on top of your servo.
7.
Repeat for the other servo in the other wing.