Lanier R/C MARINER 40 MK II ARF Instruction Manual - Installing Ailerons
Installing Ailerons
1.
Collect the following parts:
(1) Wing
(2) Ailerons ( Left & Right)
(6) Mini CA hinges
2.
Locate the pre-cut aileron hinge slots in both
sides of the wing. Using a hobby knife (#11
blade), slide the blade into each slot to make
sure it is cleanly cut.
Repeat this process with the ailerons, making
sure all hinge slots are clean.
3.
Insert the mini CA hinges half way into the
wing and the ailerons. (Use a pin inserted into
the middle of the hinge to help keep the hinge
in the middle.)
Make sure that the aileron is tight against the
wing and even with the wing tip.
Using thin CA glue, place one drop on all
hinges top and bottom.
Repeat for the second wing half.
1.
Gather the following items:
(2)18" Extension wires
(2) Wing
(2) Servos
(1) Electrical tape
(2) Servo spacers
2.
Locate the two aileron servo spacers.
Installing Aileron Servos
IMPORTANT! To ensure that any connections located
inside the wing will not come loose, either when the
wires are pulled, or during flying, always tape them
securely together with electrical tape.
3.
Lay the spacer over the cutout for the aileron
servo and mark around the outside edge.
Carefully remove the covering inside your
marks and glue the spacer plate in place.
4.
Use the string to pull the aileron wires through
the wing and exit the hole in the center sec-
tion.
5.
Mount the servo using the hardware supplied
with the servo.
6.
Repeat for the other wing.