NanoCam Plus NCP-DVR1080 User Manual - page 12
2.7.3 Exposure
Exposure is used to manually control the light sensitivity settings. To change the Exposure setting follow the instructions
below.
1. Press the (Rec/Ok) Button to stop the Car DVR from recording.
2. Press the (Menu) Button to enter the Video Menu.
3. Use the and Buttons to navigate the Settings Menu and highlight the Exposure setting and press
OK
to select.
4.
Use the and Buttons to highlight your required
Exposure setting, then press the (Rec/Ok) button to confirm your
selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2.7.4 WDR
The
WDR setting increases the dynamic range of the camera. To turn this setting on or off, please follow the instructions
below.
1. Press the (Rec/Ok) Button to stop the Car DVR from recording.
2. Press the (Menu) Button to enter the Video Menu.
3. Use the and Buttons to navigate the Settings Menu and highlight the WDR setting and press (Rec/Ok) to select.
4.
Use the and Buttons to highlight either OFF or ON, then press the (Rec/Ok) button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2.7.5 Motion Detection
Motion
Detection is used to pause recording when no motion is detected in front of the camera, and to start recording
when motion is detected again. To activate the
Motion Detection setting follow the instructions below.
1. Press the (Rec/Ok) Button to stop the Car DVR from recording.
2. Press the (Menu) Button to enter the Video Menu.
3. Use the and Buttons to navigate the Settings Menu and highlight the Motion Detection setting and press (Rec/
Ok) to select.
4.
Use the and Buttons to highlight either OFF or ON, then press the (Rec/Ok) button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
12