NanoCam Plus NCP-DVR1080 User Manual - page 17
17
3.1.6 White Balance
The
White Balance setting is used to manually adjust the settings used to counteract different light conditions. This setting
is set to Auto by default. To change the White Balance setting follow the instructions below.
1. Enter the Photo screen.
2. Press the (Menu) Button to enter the Photo Menu.
3. Use the and Buttons to navigate the Photo Menu and highlight the White Balance setting and press (Rec/Ok) to
select.
4.
Use the and Buttons to highlight your required setting, then press the (Rec/Ok) button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. This setting can only be accessed through the Photo Menu, please make sure that you are in the Photo screen when you access
the menu.
3.1.7 Colour
The
Colour setting is used to set the colour palette. To change the Colour setting follow the instructions below.
1. Enter the Photo screen.
2. Press the (Menu) Button to enter the Photo Menu.
3. Use the and Buttons to navigate the Photo Menu and highlight the Colour setting and press (Rec/Ok) to select.
4.
Use the and Buttons to highlight your required colour setting, then press the (Rec/Ok) button to confirm your
selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. This setting can only be accessed through the Photo Menu, please make sure that you are in the Photo screen when you access
the menu.
3.1.8 ISO
ISO is used to manage how much light is let into the image sensor. Setting a higher ISO will let in more light and blurred
movement and lower ISO will capture less movement and less light. To change the ISO setting follow the instructions below.
1. Enter the Photo screen.
2. Press the (Menu) Button to enter the Photo Menu.
3. Use the and Buttons to navigate the Photo Menu and highlight the ISO setting and press (Rec/Ok) to select.
4.
Use the and Buttons to highlight your required ISO setting, then press the (Rec/Ok) button to confirm your
selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. This setting can only be accessed through the Photo Menu, please make sure that you are in the Photo screen when you
access the menu.