NanoCam Plus NCP-DVR1080 User Manual - page 19
19
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. This setting can only be accessed through the Photo Menu, please make sure that you are in the Photo screen when you access
the menu.
3. The Date Stamp setting is not used to set the cameras internal clock. To set the time follow the instructions Date/Time (3.2.1) in
the settings section.
3.2 Setting Menu
This menu is used to edit the cameras operational settings. This menu can be accessed through either the
Video or Photo menu
by pressing the (Menu) button whilst in either of these menus. While in this menu the and buttons are used to navigate and
the (Rec/Ok) button to select the highlighted setting.
3.2.1 Date/Time
The
Date/Time setting is used to set the cameras internal clock. To set the internal clock follow the instructions below.
1. Press the (Rec/Ok) Button to stop the Car DVR from recording.
2. Press the (Menu) Button to enter the Video Menu.
3. Press the (Menu) Button again to enter the Settings Menu.
4. Use the and Buttons to navigate the Settings Menu and highlight the Date/Time setting and press (Rec/Ok) to
select.
5. Use the and buttons to edit the selected digit and the (Rec/Ok) button to confirm and progress to the next digit.
The final field sets the format that the date will be presented in.
6. To save and exit the time and date, press the (Menu) button.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. Once the time and date is set it can be stamped onto your footage using the Date Stamp setting. Please see section Date Stamp
(3.1.2.1) for more details.
3.2.2 Key Beeps
The
Key beeps setting is used to turn Off or On the beep that indicates a key press. To adjust the key beep settings, follow
the instructions below.
1. Ensure that the DVR is not recording.
2. Press the (Menu) Button to enter the Video Menu.
3. Press the (Menu) Button again to enter the Settings Menu.
4. Use the and Buttons to navigate the Settings Menu and highlight the Key beeps setting and press (Rec/Ok) to
select.
5. Use the and buttons to highlight ON or OFF, then press the (Rec/Ok) button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. This setting can only be accessed through the Settings Menu which can be accessed via the
Video and Photo Menus.