NanoCam Plus NCP-DVR1080 User Manual - page 7
7
2. Getting Started
2.1 Inserting Memory Card
With the Car DVR turned off and the screen facing towards you insert the memory card into the slot on the underside of the camera with
the text on the Micro SD card facing away from you. Push the memory card in until a click is heard.
Note:
1. Do not remove or insert the memory card while the Car DVR is turned on as this may damage
the memory card or corrupt the memory cards stored data.
2. Please use a Class 6 or higher rated micro SD card with a maximum capacity of 32GB.
3. Please format the Micro SD card before the initial use.
4. When removing the memory card, be careful as the card may eject quickly.
To remove the memory card
Ensure that the Car DVR is powered off, then push the memory card until a click is heard and then release the card to eject.
2.2 Installing the Car DVR
1. Remove the protective stickers from the Car DVR and the Suction Mount.
2. Slot the mount bracket into the socket on the top of the Car DVR and with the screen facing you, slide the bracket from left to
right until the bracket locks in place.
3. Press the mount base firmly against the windscreen.
2.2.1 Adjust the device position
1. Loosen the knob on the right hand side of the mounting bracket, and adjust the vertical and horizontal angle of the camera.
2. Tighten the knob to lock the position of the camera.
2.2.2 Connecting to Power
Only use the included charger to power and charge the Car DVR.
1. Once the Car DVR is securely installed on your vehicle's windscreen, plug the 12v charger into your vehicle's cigarette
lighter.
2.
Run the cable along your vehicle's console and windscreen and plug the USB Micro plug into the Car DVR.
Note:
1. It is recommended that the Car DVR is installed behind your vehicle's rear view
mirror.
2. Make sure that the camera view is not obstructed by any window tint or any other
objects.
3. When removing the suction mount be sure to release the suction mount by
switching the suction latch to the down position.