NanoCam Plus NCP-DVR1080 User Manual - page 20
20
3.2.3 Language
The
Language setting is used to select your preferred Language in the menus. To set the systems language follow the
instructions below.
1. Ensure that the DVR is not recording.
2. Press the (Menu) Button to enter the Video Menu.
3. Press the (Menu) Button again to enter the Settings Menu.
4. Use the and Buttons to navigate the Settings Menu and highlight the Language setting and press (Rec/Ok) to
select.
5.
Use the and Buttons to highlight your preferred
Language, then press the (Rec/Ok) button to confirm your
selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. This setting can only be accessed through the Settings Menu which can be accessed via the
Video and Photo Menus.
3.2.4 Frequency
The
Frequency setting is used to set the cameras frequency. To adjust the frequency, follow the instructions below.
1. Ensure that the DVR is not recording.
2. Press the (Menu) Button to enter the Video Menu.
3. Press the (Menu) Button again to enter the Settings Menu.
4. Use the and Buttons to navigate the Settings Menu and highlight the Frequency setting and press (Rec/Ok) to
select.
5.
Use the and Buttons to highlight your preferred
Frequency, then press the (Rec/Ok) button to confirm your
selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. This setting can only be accessed through the Settings Menu which can be accessed via the
Video and Photo Menus.
3.2.5 Screen Saver
The
Screen Saver setting is used to set the duration of inactivity of the camera before the screen goes into sleep mode. To
set the screen saver follow the instructions below.
1. Ensure that the DVR is not recording.
2. Press the (Menu) Button to enter the Video Menu.
3. Press the (Menu) Button again to enter the Settings Menu.
4. Use the and Buttons to navigate the Settings Menu and highlight the Screen Saver setting and press (Rec/Ok)
to select.
5. Use the and buttons to highlight your preferred duration of inactivity, then press the (Rec/Ok) button to confirm
your selection.