NanoCam Plus NCP-DVR1080 User Manual - page 14
14
2.7.9 Shrink Video Files
The
Shrink Video Files setting allows you to shrink the output size of the video files. To set your recording preferences,
please follow the instructions below.
1. Press the (Rec/Ok) Button to stop the Car DVR from recording.
2. Press the (Menu) Button to enter the Video Menu.
3. Use the and Buttons to navigate the Settings Menu and highlight the Shrink Video Files setting and press (Rec/
Ok) to select.
4.
Use the and Buttons to select requred shrink size, then press the (Rec/Ok) button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. Shrinking the video files does impact the video quality.
2.8.0 Park Mode
When activated,
Park Mode will monitor the DVR's G Sensor after you have turned off your vehicle. If an impact is detected
the DVR will power up and record a 60 second clip. To set
Park Mode, follow the instructions below.
1. Ensure that the Car DVR is not recording.
2. Press the (Menu) Button to enter the Video Menu.
3. Use the and Buttons to navigate the Settings Menu and highlight the Parking Mode setting and press (Rec/Ok)
to select.
4.
Use the and Buttons to highlight either OFF or ON, then press the (Rec/Ok) button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. Park mode requires the DVR's internal battery to be fully charged.
3. Park Mode is activated when an impact is detected and will record from that point onward.
2.8.1 Number Plate
Number
Plate
will stamp your vehicles number plate onto the footage for reference. To set the
Number Plate setting
please follow the instructions below.
1. Press the (Rec/Ok) Button to stop the Car DVR from recording.
2. Press the (Menu) Button to enter the Video Menu.
3. Use the and Buttons to navigate the Settings Menu and highlight the Number Plate setting and press (Rec/Ok) to
select.
4. Select ON and then press the (Rec/Ok) Button.
5. Use the and Buttons to select cycle through numbers and letters. The (Menu) button is used to confirm and
proceed to the next character.
6. When you have finished inputting your vehicles number plate, use the (Rec/Ok) button to save and exit.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. For date stamp to be correct the time and date must be set first. To set the time and date please see section Date/Time (3.2.1).