NanoCam Plus NCP-DVR1080 User Manual - page 13
2.7.6 Recording Audio
The
Recording Audio setting allows you to mute the microphone during recording, or set it to record. To set your recording
preferences, please follow the instructions below.
1. Press the (Rec/Ok) Button to stop the Car DVR from recording.
2. Press the (Menu) Button to enter the Video Menu.
3. Use the and Buttons to navigate the Settings Menu and highlight the Recording Audio setting and press (Rec/
Ok) to select.
4.
Use the and Buttons to highlight either OFF or ON, then press the (Rec/Ok) button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2.7.7 Date Stamp
Date
stamp will stamp the current date onto the footage for future reference. To set the date stamp please follow the
instructions below.
1. Press the (Rec/Ok) Button to stop the Car DVR from recording.
2. Press the (Menu) Button to enter the Video Menu.
3. Use the and Buttons to navigate the Settings Menu and highlight the Date Stamp setting and press (Rec/Ok) to
select.
4.
Use the and Buttons to highlight either OFF or ON, then press the (Rec/Ok) button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. For date stamp to be correct the time and date must be set first. To set the time and date please see section Date/Time (3.2.1).
2.7.8 G Sensor (Gravity Sensing)
The
G Sensor defines the required force needed to trigger emergency recording. Once Emergency recording is triggered
the current recording will be saved and protected from being saved over by the normal loop recording. To set the required
sensitivity please follow the instructions below.
1. Press the (Rec/Ok) Button to stop the Car DVR from recording.
2. Press the (Menu) Button to enter the Video Menu.
3. Use the and Buttons to navigate the Settings Menu and highlight the Gravity Sensing setting and press (Rec/
Ok) to select.
4.
Use the and Buttons to highlight either OFF or ON, then press the (Rec/Ok) button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. If your memory card is filling up quickly you may need to lower the sensitivity of the G Sensor
(Gravity Sensor) to decrease
the number of triggers caused by normal driving.
13