National Instruments NI 9516 Operating Instructions And Specifications - Note
10
|
ni.com
|
NI 9516 Operating Instructions and Specifications
1. Install the module in the chassis as specified in the chassis
documentation.
Note
Refer to the
NI SoftMotion Module book of the
LabVIEW Help for information about chassis, slot, or
software restrictions.
2. Connect the module to a drive and other I/O using the
NI 9514/16 to AKD cable, the NI 951x Cable and Terminal
Block Bundle, or a custom cable for direct connectivity to
third-party drives.
3. Connect the NI 9516 module to an external power supply.
Caution
Do
not
connect anything to pins marked
Reserved.
Caution
The 37-pin terminal block has separate Vsup
and COM terminals for each connector. Make sure you are
using the correct Vsup and COM terminals for the
connector you are using. All signals associated with
the DSUB connector in Figure 3 are marked with a
dagger (†).
Figure 1 shows a simplified system connection diagram.