North Invent SL150-01.MON.03 User Manual - Sealine Mk3 Monitors
SeaLine MK3 Monitors
Specifications subject to changes without prior notice.The contents of
this page are property of North Invent Norway AS. All rights herein are
reserved to North lnvent Norway AS. This document cannot be
reproduced without the written permission of the company.
NORTH INVENT
Sørhauggata 128, NO-5527 Haugesund, Norway
Phone: + 47 48 84 02 00
post@northinvent.com www.northinvent.com
13
1.5 Mechanical installation
All our Monitors are delivered with all necessary accessories as specified on the order confirmation.
x Front mounting
- When the Monitor is flush mounted, one must imperatively use the 4 x M6 screws and covers enclosed in the
delivery. The tightening moment must be of 8-10 Nm.
x Stand mounting
- The Monitor is fixed to the Stand by using the 4 x M6 screws and covers enclosed in the delivery. The
tightening moment must be of 8-10 Nm.
- The viewing angle of the Monitor can be adjusted from -12° to 90° (vertical) and maintained in position by
using the manual screws on each side of the Stand. Pull out the screws and turn them anticlockwise until
they are loose. Move the Monitor to the desired viewing angle and turn the manual screws clockwise this
time, until they are tightened again.
- If the Monitor is exposed to severe vibration or shock, firmly maintain it in position by using 2 x M10 nuts on
each side of the Stand.
- 2 versions of stand are available thin (single layer) or thick (double layer). The reinforced stand will be more
stable for bigger Monitors size, such as the 19”, 21.3” and 23.1” ones.
x Turntable mounting
- When ordered together, the Turntable comes mounted on the Stand on delivery.
- Orientation of the Monitor can be made from 0-360° by simply turning the Monitor with a slight lateral
pressure on the turntable. The forced needed to turn the Monitor can be adjusted using the M10 nuts on the
top of the Turntable. Remove the plastic covers and loose or tighten the screws. Remember to reposition the
plastic covers again.
- If the Monitor is exposed to severe vibration or shock the M10 screws can be tightened at 8-10 Nm.
Remember to loose the screws before adjusting the Turntable again.
- The Monitor is fixed to the Stand by using the 4 x M6 screws and covers enclosed in the delivery. The
tightening moment must be of 8-10 Nm.
x Sunshade mounting
- The Sunshade is fixed to the Monitor by using the 4 x M3 screws and covers enclosed in the delivery.
- Remove the 4 screw covers from the Monitor’s frame and position the Sunshade on the Monitor. The
Sunshade screws will fit into the hole and shall be tightened at 2-3 Nm. Remember to position the covers
again.