North Invent SL150-01.MON.03 User Manual - Sealine Mk3 Monitors
SeaLine MK3 Monitors
Specifications subject to changes without prior notice.The contents of
this page are property of North Invent Norway AS. All rights herein are
reserved to North lnvent Norway AS. This document cannot be
reproduced without the written permission of the company.
NORTH INVENT
Sørhauggata 128, NO-5527 Haugesund, Norway
Phone: + 47 48 84 02 00
post@northinvent.com www.northinvent.com
19
2.4.2 OSD items
-
Depending on the menu chosen, different types of items can appear:
Push button - activates a sub-menu or a function
List - a value can be chosen from a list
Slide bar – slide the bar to choose the desired level from 0-100%
ON/OFF - turns the settings On or Off
Information - contains pure text or value information
2.4.3 OSD items stages
- Folder items, menu items, and sub-menu items exist in three different stages:
Inactive - when the OSD is opened all folders, menus, and sub-menus are by
default inactive, and the only item that is selected is the ‘Tools’ folder.
Selected - when the user navigates through the OSD, part of the selected item is
blue. It can not be adjusted before activated (Press ENTER).
Activated - the item is activated and can be adjusted. To activate an item, push
the ENTER button on the HMI (Human Machine Interface).
2.4.4 Entering and adjusting the OSD
- The OSD menu can always be opened and closed by pressing the MENU button on the HMI (except when
locked, see 2.4 on page 16). Once the menu has been opened it can be navigated up/down and right/left
using ‘+’ and ‘-’ buttons. To be able to adjust the settings, an item has to be active, which is effectuated by
pressing the ENTER button.
- To make adjustments in the OSD, follow these steps:
1. Press the MENU button on the HMI to activate the OSD.
2. Navigate up and down in the different folders with ‘+’ and ‘-’ buttons.
3. When the desired folder is partly highlighted, press the SET button to activate the menu.
4. Navigate with the + and - buttons until the desired control has been reached (and partly highlighted).
To gain adjustment control, press SET. The control will be highlighted and can now be adjusted.
5. Press + to increase the value or - to decrease the value.
6. When the right level has been reached, press SET once again to activate the adjustment and
automatically jump one level back.
7. To exit the OSD, press MENU.