North Invent SL150-01.MON.03 User Manual - Sealine Mk3 Monitors
SeaLine MK3 Monitors
Specifications subject to changes without prior notice.The contents of
this page are property of North Invent Norway AS. All rights herein are
reserved to North lnvent Norway AS. This document cannot be
reproduced without the written permission of the company.
NORTH INVENT
Sørhauggata 128, NO-5527 Haugesund, Norway
Phone: + 47 48 84 02 00
post@northinvent.com www.northinvent.com
16
2.
Operating Instructions
The following instructions assume that the Monitor has been correctly installed and that the commissioning work
has been finalised.
2.1 Controls and indicators
- Controls and Indicators are placed on the User Panel in the lower right side of the Monitor.
- Normal functioning of the Control knobs and Indicators are explained in the following table:
Control / Indicator
Function
POWER
Press once to switch the Monitor ON.
Press for 5 sec to switch the Monitor OFF.
AC
Indicates that the Monitor is supplied with 115 or 230 VAC.
DC
Indicates that the Monitor is supplied with 24 VDC
LOCK
Press once to activate the OSD in unlocked state.
Press LOCK and MENU for 5 sec to unlock and activate the OSD in
locked state.
MENU
Press once to activate the OSD in unlocked state.
Press once to deactivate the OSD again.
Press once to change from sub to main menu.
SET
Press to indicate/change the video input source (OSD not active).
Press once to go to the selected sub menu (OSD active).
Press once to set or unset the selected sub menu (OSD active).
+
Press and hold to increase the indicator brightness (OSD not active).
Press once to select the next menu (OSD active).
Press or hold to increase values (OSD active).
−
Press or hold to decrease the indicator brightness (OSD not active).
Press once to select the previous menu (OSD is active).
Press or hold to decrease values (OSD active).
DIMMING KNOB
Turn clockwise to increase the screen’s backlight (brightness).
Turn anticlockwise to decrease the screen’s backlight (dimming).
Figure 2. Front Panel with controls and indicators.
2.2 Start-up
- Ensure that power and a valid video signal are supplied to the Monitor. Standard video signals are listed in
the Mode Table section below.