North Invent SL150-01.MON.03 User Manual - Sealine Mk3 Monitors
SeaLine MK3 Monitors
Specifications subject to changes without prior notice.The contents of
this page are property of North Invent Norway AS. All rights herein are
reserved to North lnvent Norway AS. This document cannot be
reproduced without the written permission of the company.
NORTH INVENT
Sørhauggata 128, NO-5527 Haugesund, Norway
Phone: + 47 48 84 02 00
post@northinvent.com www.northinvent.com
35
3.2 Firmware Revision table
Monitor Rev.
Software
Rev.
Description
Date
Signed by
1.0
1.1
Original version
1.0
1.2
New start-up logo
12-12-2007
1.0
1.3
New ECDIS functions (not
implemented)
01-03-2008
1.0
1.4
First release
12-06-2008
1.0 (15”,19” and
21”)
2.0 (23”)
1.5
1.6
New lock function, 62288
and 62388 adaption
As 1.5 + LED control
05-10-2009
07-05-2010
SU
SU
1.0 (15” and 21”)
2.0 (19”)
2.0 (23”)
1.5
1.5
1.6
LED backlight
27-08-2013
SU
3.3 Troubleshooting
- There are several possible solutions to the same problem – please try the first one on the list and then move
on to the next if the problem persists.
PROBLEM
POSSIBLE SOLUTION
No AC or DC indication and no picture
on the screen
Press the POWER control shortly, then press and hold the +
control for a while
No AC or DC indication and no picture
on the screen
Check the AC and/or DC power cable and make sure that
voltage is present at the terminals
No picture on the screen but AC and/or
DC indication is on
Turn the KNOB (brightness) control fully clockwise
No picture on the screen but AC and/or
DC indication is on
Press the MENU control (or press and hold the LOCK control for
5 sec) and select the correct video source with the OSD
No picture on the screen but AC and/or
DC indication is on
Check that a valid video signal is present on the selected source
– use e.g. another Monitor
The picture do not fit the screen size
Adjust the picture positions and frequency with the OSD
The picture cannot be adjusted to fit the
screen size
Check if the video solution and frequency are included in the
Mode Table
above
The backlight cannot be adjusted from
totally darkness to full brightness using
the KNOB control
Adjust the backlight to 50 % with the OSD.
The backlight cannot be adjusted from
totally darkness to full brightness using
the remote control
Set the KNOB control in its calibrated setting (little mark above
the KNOB)
Part of or whole picture is blurred
Adjust the picture phase with the OSD