North Invent SL150-01.MON.03 User Manual - Sealine Mk3 Monitors
SeaLine MK3 Monitors
Specifications subject to changes without prior notice.The contents of
this page are property of North Invent Norway AS. All rights herein are
reserved to North lnvent Norway AS. This document cannot be
reproduced without the written permission of the company.
NORTH INVENT
Sørhauggata 128, NO-5527 Haugesund, Norway
Phone: + 47 48 84 02 00
post@northinvent.com www.northinvent.com
15
x
VGA cable (Analog RGB)
- The VGA cable is included in the delivery.
- Remember to fasten the VGA cable’s fixing screws for adequate connection.
x
DVI cable (Digital RGB)
- The DVI cable is not included in a standard delivery but is available as an option.
- The DVI cable is to be connected to the DVI-I terminal.
- Remember to fasten the DVI cable’s fixing screws for adequate connection.
x
Video cables
- Video signals can be obtained by connecting the Monitor to the S-VHS (S-Video) and CVBS (composite
video) terminals. The video cables must be of high quality in order to avoid signal’s interference.
x
RS232 cable
- The Monitor is equipped with a standard 9-pin D-SUB female connector for RS232 remote control.
- Further information about this interface and the remote control is to be found in the Remote Control section.
x
Compass safe-distance
- Every component of type approved equipment is tested in order to determine the minimum safe distances at
which it should be installed from both the steering and the standard magnetic compasses, so not to
significantly affect the accuracy of these compasses. The safe compass distances are mentioned on every
Monitor or in the accompanying handbook. A safe distance takes into account both the constant effect on a
magnetic compass, of the presence of magnetic material but also any variable effect due, for instance, to
electrical circuits or the opening/closing of drawers or panels. Thus, provided that a Monitor is not placed in a
position nearer to the centre of the bowl of a magnetic compass than the recommended safe distance, the
Monitor may be installed or removed without any need for adjustment of that compass.
- SL150-01.MON.03 1.00m
- SL190-02.MON.03 1.55m
- SL213-01.MON.03 1.60m
- SL231-02.MON.03 2.10m
- The safe distance is also indicated on the terminal plate of every Monitor as shown on Figure 1.
Figure 1. Terminal Plate for a 19” Sea Line Monitor.