North Invent SL150-01.MON.03 User Manual - Sealine Mk3 Monitors
SeaLine MK3 Monitors
Specifications subject to changes without prior notice.The contents of
this page are property of North Invent Norway AS. All rights herein are
reserved to North lnvent Norway AS. This document cannot be
reproduced without the written permission of the company.
NORTH INVENT
Sørhauggata 128, NO-5527 Haugesund, Norway
Phone: + 47 48 84 02 00
post@northinvent.com www.northinvent.com
26
Size: The size of the PIP picture is chosen here.
Horizontal position: The chosen value decides where the PIP picture is
placed horizontally on the display starting from the upper left corner.
Vertical position: The value decides where the PIP picture is placed
vertically on the display from the upper left corner.
If ‘Side by side’ is chosen,
the
following
menu
is
displayed:
See above for further explanation.
RGB mode wizard
- This folder is only shown when an RGB signal is present on a RGB input.
- For a detailed explanation of the technology behind a RGB signal, for a deeper understanding of how to
adjust the Marlin scalar board to accept non standard RGB signal, please refer to 14400001 RGB signal
detection.
Control
Function
Mode selection is a set of parameters telling the display where and how to
display the picture (horizontal total, phase, horizontal resolution, vertical
resolution, horizontal position, and vertical position).
It is possible to enter up to 10 different mode selections:
1) Activate the ‘Mode selection’
2) Choose the desired no.
3) Adjust settings under horizontal total, phase, horizontal resolution,
vertical resolution, horizontal position, and vertical position.
4) Enter and activate the ‘Save mode parameters’
Value: 0-9
Pure information stating the current resolution and Hz. value: No value -
pure text.
Automatically sets the resolution, position, and phase of the picture on the
display.
Loads the current mode parameters.