North Invent SL150-01.MON.03 User Manual - Sealine Mk3 Monitors
SeaLine MK3 Monitors
Specifications subject to changes without prior notice.The contents of
this page are property of North Invent Norway AS. All rights herein are
reserved to North lnvent Norway AS. This document cannot be
reproduced without the written permission of the company.
NORTH INVENT
Sørhauggata 128, NO-5527 Haugesund, Norway
Phone: + 47 48 84 02 00
post@northinvent.com www.northinvent.com
21
Tools
Control
Function
Backlights are used to illuminate displays. In small displays they are often used
to increase readability in low light conditions. The OSD allows for the backlight
to be dimmed from 100 – 0%. At 0%, the backlight is turned off.
Value: 0-100%
LED brightness
When showing a graphic signal or video signal, the following scaling modes
exists:
Normal
: Scaling mode depends on panel and source signal aspect ratio. This
mode preserve the correct aspect ratio of the input signal, so if a 4:3 signal is to
be displayed on a 16:9 display this adds black bars on both sides.
One to one
: 1:1 representation of the input signal. If a 640x480 signal is to be
displayed on a 1024x768 panel, you will see the picture centered using
640x480 pixels shown with a black frame around it.
Fill all:
Regardless of input and output resolutions the input picture is scaled to
fit the screen.
Auto:
This means that for Composite or S-Video signals, provided Wide Screen
Signalling (WSS) is available, input signal is automatically scaled depending on
the ancillary data transmitted. This is usually sent by TV broadcasters or by
DVD players according to the aspect ratio of the video.
Anamorphic
: For 16:9 signals generated by DVD players (the signal is 16:9 but
is stretched to fill the screen with no black bars, so the picture, if displayed on a
4:3 screen, would result in tall people). This will de-stretch the picture so that
the given correct aspect ratio is restored.
Auto and Anamorphic will only appear if video input has been chosen.
Value: Normal, One to one, Fill all, Zoom, Auto and Anamorphic
If a still picture is needed, the present frame can be frozen by selecting ON in
this property.
Value: ON/OFF