North Invent SL150-01.MON.03 User Manual - Sealine Mk3 Monitors
SeaLine MK3 Monitors
Specifications subject to changes without prior notice.The contents of
this page are property of North Invent Norway AS. All rights herein are
reserved to North lnvent Norway AS. This document cannot be
reproduced without the written permission of the company.
NORTH INVENT
Sørhauggata 128, NO-5527 Haugesund, Norway
Phone: + 47 48 84 02 00
post@northinvent.com www.northinvent.com
22
Sets the duration for the time-out of the OSD menu, that is, how many seconds
should pass with menu inactivity before the menu closes.
Value: 5-20 sec, No timeout
How many seconds the logo will be shown on the display at start-up is adjusted
here.
Value: 1-20 sec, No logo
Sets the time that should pass before the display changes state to power save
after input signal is removed.
Value: 1-20 min, No timeout.
Locks the keypad. To unlock the keypad again, press the LOCK and the MENU
buttons for 5 seconds.
Value: ON/OFF
WARNING: Do not lock keypad if only IR remote is used. The access is only
granted through keypad or RS232, NOT through the IR remote
Reinstalls the settings provided by the factory.
Note: The OSD menu will automatically close after choosing ‘Factory Default’
A setup is a combination of settings adjusted by the user. It is possible to save
up to 3 different setup combinations (0, 1, and 2). The procedure is:
1) Adjust the desired settings
2) Enter the ‘Setup selection’ and choose 0, 1, or 2
3) Choose the ‘Save Monitor setup’
Value: 0, 1, or 2
Saves the present settings entered by the user (See explanation above).
Recalls the settings depending on which ‘Setup Selection’ is chosen:
1) Choose the desired setup under ‘Setup selection’
2) Activate the ‘Recall Monitor setup’ button
Horizontal position of the OSD menu on the display.
Value: 0-100