Oceanic VEO 2.0 Operating Manual - page 30
30
Set F Lead-in, information includes (Fig. 15):
> Graphics SEt and F
• A (< 2 sec) to step forward to Set A Lead-in.
• S (< 2 sec) to access Set FO2.
Set FO2, information includes (Fig. 16, 17):
> Graphic SEt if Air; or Max Depth allowed for the PO2
alarm set with FT (or M) and NX icons if Nitrox
> PO2 alarm value set (ATA) with PO2 and MAX icons, blank
if Air
> Graphic Air, or numeric FO2 Set Point value if Nitrox,
flashing, with FO2 icon
• A (hold) to scroll upward through Set Points at a rate of
8 per second from Air (default) to 21 through 100 (%) in
increments of 1%.
> The scroll will stop when A is released, or at 32%, (even if A is held
depressed). Pressing and holding A again will resume the scroll through
50, then stop at Air or 21%.
• A (< 2 sec) to step upward through Set Points one at a time.
• S (< 2 sec) to save the setting and access Set FO2 Default.
• S (2 sec) to revert to Set FO2 Lead-in.
Fig. 16 - SET FO2 (Air)
Fig. 17 - SET FO2 (Nitrox)
Fig. 15 - SET F LEAD-IN