Oceanic VEO 2.0 Operating Manual - page 93

93

Battery Cover Removal

•  Turn the module over to expose the Battery Cover.

•  While applying steady inward pressure on the center of 

the Battery Cover, rotate the Retaining Ring 10 degrees 

clockwise by pressing against the upper tab of the Ring 

with a small blade screwdriver (Fig. 109). 

•  Lift the Ring up and away from the Housing, or turn the 

Module over to allow the Ring to drop out into your hand. 

•  Remove the Battery Cover.  

Battery Removal

•  Remove the Retaining Bar located across the lower portion 

of the Battery (Fig. 110a).  

•  Remove the Cover O-ring.  DO NOT use tools.

•  Slide the Battery up and out of the Battery Compartment.

Inspection

•  Closely check all of the sealing surfaces for any signs of 

damage that might impair proper sealing.  

•  Inspect the Button, Lens, and Housing to ensure they are not 

cracked or damaged.

WARNING:  If damage or corrosion is found, 

return your VEO to an Authorized Oceanic 

Dealer, and DO NOT attempt to use it until it has 

received factory prescribed service.

Fig. 109 - COVER RING

Fig. 110 - RETAINING BAR

a