Oki MC770 series Maintenance Manual - page 97
45376001TH Rev.1
96 /
Oki Data CONFIDENTIAL
4. Component replacement
4.2.33
Guide-Retard / Roller / Motor / Clutch / Solenoid/
Photo-sensor
(1) Pull and remove Guide-Cable-ADF ① .
(2) Remove the E-type retaining ring ② and remove the clutch ③ .
(3) Remove the three screws (black, No:42932706) ④ and remove the plate-motor-
ADF ⑤ .
(4) Remove the two screws (silver, No:42920406) ⑥ and remove the motor-pulse-
belt ⑦ from ⑤ .
(5) Remove the E-type retaining ring ⑧ and remove the clutch ⑨ .
(6) Open the Cover-Assy-Top-ADF ⑩ ,and warp around a post to Arrow A to
remove Cover-Assy-Top-ADF ⑩ .
(7) Disconnect a cable, and warp around post to Arrow B to remove the Guide-
Retard-A ⑪ .
(8) Remove the Guide Separator Hop ⑫ .
(9) Remove the three screws (black, No:42932706) ⑬ and Plate-Drive ⑭ .
(10) Remove the Feed roller ⑮ .
(11) Remove two screws(silver, No:42920406) ⑯ and remove the solenoid ⑰ .
(12) Warp around post to Arrow C to remove Guide-B ⑱ .
(13)Warp around post to Arrow E to remove Guide-Separator ⑲ .
(14)Disconnect all cables and warp around post to Arrow D to remove the Guide-
Assy-C ⑳ and remove .
(15)Warp around post to Arrow F to remove the Guide-Assy-D and remove the
photo-sensor .
(16)Warp around post to Arrow G to remove the Guide-Retard and the Guide-Exit-
Lower and remove photo-sensor .
⑩
⑪
Arrow A
⑦
⑰
⑨
③
⑧
㉔
㉕
㉒
㉑
㉓
⑲
⑳
⑱
①
③
⑥
⑥
②
④
⑬
×3
⑭
⑮
④
⑤
⑯
Arrow B
Arrow D
Arrow E
Arrow C
⑫