VCON VIGO Installation And Setup Manual - page 25
Chapter 2 System Installation and Connections
VCON ViGO Installation and Setup Guide
2–11
Connecting the ViGO to a Computer
The ViGO is a Plug and Play appliance. When you connect it to your computer’s
USB port, it operates normally with no need to change the configuration or other
system properties of the computer.
³
To connect the ViGO to a PC, laptop or notebook computer
USB Connector Types
2. Turn on all accessories and peripherals (such as cameras, VCR,
multimedia speakers) connected to the ViGO.
3. To turn the ViGO on, press the Power switch on the ViGO rear panel to I .
Make sure that the POWER LED and the desktop camera’s green LED
turn on. A message may state that Windows is loading a new USB driver.
Wait a few seconds for the message to disappear.
4. Press the ViGO Smart button on the top of the base to start vPoint.
When you start vPoint for the first time, the vPoint Wizard requests basic
configuration information.
Otherwise, vPoint opens on your screen as usual.
For detailed information about operating vPoint, see the application’s
online help.
CAUTION Before connecting the ViGO to your computer, you must install
the vPoint software. See Chapter 3,
“vPoint Setup”
, for
instructions.
1. Connect the ViGO’s USB cable between the USB B connector on the
ViGO rear panel and the computer’s USB A port.