VCON VIGO Installation And Setup Manual - Modifications
iv
VCON ViGO Installation and Setup Guide
Modifications
The FCC requires the user to be notified that any changes or modifications made to
this device that are not expressly approved by VCON Ltd. may void the user’s
authority to operate the equipment.
Safety Notice
The VCON system should only be connected to and operated in SELV (Safety
Extra Low Voltage) computers. The VCON system should only be connected to
computers that have a limited power source according to section 2.11 of the EN
60950 Safety Standard or to a computer that has a fire enclosure according to
paragraph 4.4.6-4.4.8 of the EN 60950 Safety Standard. After being connected to
the computer, only the external connectors should be accessible to users.
About this Installation and Setup Guide
This Installation and Setup guide explains how to set up the ViGO, connect its
accessories, and install and set up the vPoint conferencing application.
The following chapter summary briefly describes this guide’s contents:
Chapter 1
Welcome to ViGO
Introduction to this Installation and Setup Guide
Chapter 2
System Installation and Connections
Procedures for connecting the standard equipment to the
ViGO.
Chapter 3
vPoint Setup
Procedure for installing the vPoint application.
Chapter 4
ViGO Controls and LEDs
Summary of the functions of the buttons and LEDs on
the ViGO unit’s base.
Chapter 5
Troubleshooting
Solutions for possible problems that you may encounter
with the ViGO.
Appendix A
Connecting Optional Accessories
Procedures for connecting optional accessories and
peripheral equipment to the ViGO.